Viking Longhouse Roof

These columns divided each interior room into three long aisles.

Viking longhouse roof. Nov 4 2019 the longhouses of the vikings. The columns supported the roof and as a result the walls supported little weight. See more ideas about vikings viking house viking age. Longhouses were usually made of wood stone or earth and turf which kept out the cold better.

Model longhouse version 1 a basic model of a viking longhouse can be made using stripwood techniques and card. Where wood was scarce as in iceland longhouses were made of turf and sod. The longhouse had curved walls that almost makes the roof look like a ship flipped on its head. No matter the size the basic construction was the same.

Ran down the length of the longhouse supporting the roof beams. They would make two wooden posts to support the roof that would then run over the whole structure. The roofs were often multi layered and they usually had a tower or spire in the middle of the highest layer of the roof. Houses were built by using wood from oak trees in the viking age.

Countryside buildings were built of wood and they were similar to log cabins. They were around 5 7 metres 15 25 feet wide in the middle and from 15 75 metres 50 250 feet long. This kind of building predates back to iron age sites around the same time the vikings existed. These buildings were used for farming the roofs were covered with earth and grass was planted in the soil.

The walls were either made from clay or wood planks. The icelandic turf houses and the viking longhouse were general living buildings in medieval scandinavian architecture. Longhouses would vary in size based on the importance of the owner. They were built of wood and had stone walls around the base.

Vikings lived in a long narrow building called a longhouse. There would also be small three legged stools and perhaps larger boards and trestles stored in the roof beams and brought down for feasts and special occasions. Two rows of wooden columns ran the length of the house supporting the high points of the roof. Two rows of high posts supported the roof and ran down the entire length of the building which could be up to 250 feet long.

Typically the walls bowed out at the center of the longhouse making it wider in the center. Most had timber frames with walls of wattle and daub and thatched roofs. This is very suitable as group project since separate frames can be made by different teams then brought together to assemble at the end. The roof was supported with large posts that were dug into the ground.