Use Accelerometer To Ajust Solar Panels

A dynamic accelerometer measures the gravitational pull.

Use accelerometer to ajust solar panels. Choose location configure your pv system and simulate. A 3d accelerometer mounted to the rear of the panel feeds back an analog value to the mightyboard proportional to the tilt of the panel. Available 4 simulators. If your laptop drops suddenly while you are using it an accelerometer can identify causes of the sudden free fall and turn off the hard drive right away to avoid any data damage.

The solar eye system is a precision control system that automatically maintains light intensity through a feedback loop. Gyros accelerometers magnetometers typically use i2c. The energy that a panel can produce will vary by its location and its available sunlight but in general most home solar panels have power output ratings ranging from 250 to 400 watts with an. You only require two wires sda and scl for one or more than one device on the bus.

Most accelerometers will have a selectable range of forces they can measure. The bottom edge of the solar panel is mounted with two door hinges with a motorized screw jack used to raise and lower it. Measure solar radiation with an appropriate light meter to make sure that the solar radiation is at or above 650 w m. The solar eye system provides.

An equation is used to translate this from voltage values to tilt in degrees. The accelerometer can be used for both academic and consumer purposes. When choosing which accelerometer to use several features are important to consider including power requirements and communication interfaces as discussed previously. Get ready to simulate your desired pv system for any chosen location.

These ranges can vary from 1g up to 250g. Also since just looking at it isn t enough an accelerometer is also used to operate the water tank with your finger. When you buy one make sure that it is 5v tolerant or compatible with 5v etc. Or you ll get stuck adding in level shifting.

Additional features for consideration are below. User friendly interface and easy to use. The power supply uses solar panels the microcomputer board is the easy to use and compact arduino pro mini 328 while the display device uses a full color serial led tape that is easy to wire. The controller monitors uv intensity and compensates for lamp aging and variability by adjusting power to the lamps.

The system uses a gps to provide geographical position day and time. In direct sunlight solar panels work at full capacity and damaged solar cells will show clearly on the infrared image.